Your satisfaction with your Pella windows and doors is our highest priority. If you have a problem with your Pella product that you suspect could be related to the window’s installation, completing the following steps can help determine if the product is installed level, square and plumb.
First, get a level and set it on the frame of the product, across the bottom or sill. Do not put it on the sashes or panels of the product as it could give an inaccurate reading. The bubble of your level should rest in the center, demonstrating the product is installed level.
Next, test plumb of your window or door. Plumb means the window or door is straight down or up, vertically. To test for plumb, set your level on the two vertical side jambs on the exterior face to ensure the product is plumb from the inside out. Next, you’ll check for plumb from left to right by placing the level on each of the two sides. The bubble should fall in the center on both sides, representing that the product is installed plumb.
When you finish checking plumb, you can check for bowing by measuring the unit horizontally across the top, middle and bottom. The measurements of each of the three places should all be equal, allowing 1/8 inch of leeway. It’s crucial to always measure to and from the same point on both sides for consistency. Lastly, determind if your window or door is square by measuring from each corner to the other in an X fashion on the outside of the product. The measurements should be within 1/8 inch of each other for the product to be
You can also inspect the reveal, where the sash meets the frame. The gap should appear the same from top to bottom and left to right. All sides of your product should appear the same, signifying the product is installed level, square, and plumb.
Doing a little troubleshooting on your own can offer helpful information to resolve a problem. If it is clear you have run in to one, or even a couple, of these issues, come by the Pella Window and Door Showroom in Bloomington or give us a call at 309-663-7132.